At the end of the installation, it is recommended to clean the floor with a vacuum cleaner. Subsequently, for the final cleaning of the construction site, pass the floor with concentrated detergent PU CLEANER Dr. Schutz.

For the initial protection of Vinyl and Green floors just laid and thoroughly cleaned, apply FLOOR MAT Dr. Schutz protective matt; the product, once dry, forms an opaque non-slip finish on the surface. Shake the bottle well before use. Then apply a uniform, thin and undiluted layer along the length of the floor laid on the entire surface, previously cleaned. Allow the film to dry for at least 12 hours before treading the floor.

In the case of stubborn dirt on Vinyl and Green floors, dilute PU CLEANER at a ratio of 1:10 (1 liter of product for every 10 liters of water), reducing the concentration appropriately for light soiling; distribute the cleaning solution on the floor with a damp cloth and, after letting it sit for a short time, pick up the dirt using an absorbent, broad-headed cloth. Finally rinse with a cloth moistened with clean water, well wrung out.

For daily cleaning of all floors, dilute PU CLEANER in a ratio of 1:200 (50 ml of product per 10 litres of water). This product does not cause damage to the floor surface or greying (formation of grey films). Note: Sensitive surfaces (such as wood, metal, furniture) should not be sprayed directly with the cleaning solution.